Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASE READ THE MANUAL CAREFULLY AND KEEP IT FOR FUTURE REFERENCE.
CHARGING THE BATTERY
Plug the small connector of the adaptor into the charging port (5) on the top of the speaker and the other end
into a wall outlet.
The display (14) shows the battery level that increases during charge until it is full. When the battery voltage
runs low, a tone will be heard, indicating that the battery needs to be charged.
1. PRIOR TO USING THE UNIT FOR THE FIRST TIME, PLEASE CHARGE FULLY THE BATTERY
2. CHARGE THE BATTERY REGULARLY AFTER EACH USE. DON'T WAIT UNTIL IT IS DISCHARGED!
3. DON'T allow the battery to discharge completely, otherwise it will lose 20% of its capacity or even be
totally damaged! If the voltage becomes too low, the internal circuits are not powered anymore and it will
become impossible to recharge the battery!
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40% of its capacity
and check/charge it once per month.
WE CANNOT BE HELD RESPONSIBLE FOR DAMAGED BATTERIES FURTHER TO THE NON-OBSERVAN-
CONTROLS
1. MIC input
2. AUX input
3. TF input
4. USB input
5. DC 9V input
6. MENU
7. REC
8. MODE/MIC PRI
9. On/Off
10. Previous Track / CH-
11. Play/Pause/TWS
12. Next Track / CH+
13. LED Switch
14. Display
15. Volume control
USB OPERATION
Insert a USB device into USB port (4) to play music stored on the drive. The play will start automatically.
MICRO-SD OPERATION
Insert a micro-SD card into TF port (3) to play music stored on the drive. The play will start automatically.
BLUETOOTH OPERATION
1. POWER button: Long press the POWER button (9) to turn the speaker on. The display (14) will slowly flash
"bLUE" to indicate that the speaker is on. Keep the POWER button (9) pressed to turn the unit off. The
display (14) will always show "bLUE" when connected.
2. Turn on the Bluetooth function on your external Bluetooth device and search for "MUSICA" . Enter the
password "0000" if required. After a successful pairing, you will hear a sound.
USE WITH A WIRED DEVICE
To use the speaker as a wired device, plug one connector of the 3.5mm audio cable into the 3.5mm auxiliary
audio input jack (2) on the speaker. Plug the other connector into the headphone jack of your media-playing
device. Press the button MODE (8) to switch to LINE mode. The display (14) will show "LINE", while connected.
Playback is controlled via the wired device.
MAD-MUSICA50
INSTRUCTION MANUAL
IMPORTANT NOTE ON LITHIUM-ION BATTERIES
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
CE OF THESE BASIC RULES.
Code: 10-5571MA
3
Publicidad
