Orbegozo FH 5040 A Manual De Instrucciones página 14

FH 5040 A – FH 5140
GENERAL DESCRIPTION
A. Carrying handle
B. Thermostat knob
C. Selector switch
D. Control lamp
E. Air inlet grille
F. Air outlet grille
INSTRUCTIONS FOR USE
The selector switch and the thermostat knob enable you to select the
following functions:
Selector switch:
Ο : OFF. Both the fan and the two heating elements are switched off
: "Cool air". Only the fan is switched on
I : "Warm air for gradual heating-up. ECO position (1000 W): the fan and one of the heating elements are
switched on.
II : "Hot air" for quick heating-up. Full power (2000 W): the fan and the two heating elements are switched
on.
Thermostat knob:
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
position I or position II the heater will automatically switch on as soon as the room temperature falls below
the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower temperature
setting.
You may adjust the thermostat during use.
Control lamp:
The control lamp indicates the operation if any st
 If the steps switch turned on position 0 or the device by the electricity mains is taken, the control lamp
goes out.
Position
This heater can be placed on vertical or horizontal position as following pictures show:
ep is turned on in combination with the thermostat switch.
14