Newa More NMO 20 CRNE Instrucciones Y Garantía página 32

• the brightness level during the night-time phase from 0 to 15%.
WARNING: This customisation can only take place during these phases. It is not possible to use the dimmer
function during the sunrise or sunset phases.
e) Both the sunrise and sunset phases last 40 minutes each and directly affect the duration of the daytime phase (Fig.32). As a
result, when you calculate the duration of the daytime phase, consider a reduction of 80 minutes (1h 20'). For example: to make
the daytime phase last 10 hours, compared to the factory settings, the actual daytime phase will be 8 hours and 40 minutes
(Fig.34).
Operation and duration of the preset program (Fig.33):
UK
The LED strips fitted in NEWA MORE aquariums feature a program preset by the manufacturer with:
• Duration of daytime phase: 8 hours including the sunrise phase (40 minutes) and the sunset phase (40 minutes);
• Total full daylight: 6 hours and 40 minutes;
• Duration of night-time phase: 16 hours.
The program described above starts when the lighting system is activated for the first time by plugging it into the power outlet
or after a power failure lasting more than 40 minutes.
The preset program will start its cycle from the daytime phase with the LEDs at their maximum power, skipping only the sunrise
phase and continuing as described above. The sunrise phase will be restored the next day, maintaining the complete day/night
cycle, following the durations of each phase starting from the time when it was first activated
(or when the power supply is restored after a power failure lasting more than 40 minutes).
WARNING: Each time the electrical power supply is connected, the lighting system will calibrate the touch keys.
This operation lasts about 3 seconds.
Customised programming:
To customise the day/night cycle, by changing the preset program, the timer is easily programmable by following the instructions
below.
WARNING: customisation involves changing the times of the preset program (8 hours for the daytime phase and
16 hours for the night-time phase) and only affects the hours of the daytime phase, while the duration of the
night-time phase will be adjusted accordingly to cover the 24 hours daily.
I. Access the programming phase by pressing the keys
If successful, all the LEDs will flash.
II. To increase the daytime phase, press the
program;
III. To decrease the daytime phase, press the
program;
Each time the respective keys are pressed, the lights of the LED strip will turn on to confirm that the command to increase or
reduce the daytime phase has been received.
IV. Exit the programming function by not pressing any key on the touch screen for more than 15 seconds. During this time, the
LEDs will continue to flash to indicate that the programming function is still active.
V. When the programming function is deactivated, the LEDs will turn off for a few seconds and then flash for a number of times
equal to the total number of hours set for the daytime phase.
VI. The preset program will start its cycle from the daytime phase with the LEDs at their maximum power, skipping only the
sunrise phase. This phase will be restored the next day, maintaining the complete day/sunset/night cycle and following the
durations of each phase starting from the time the programming was started.
+ together for about 2 seconds
"+1h" key as many times as required, compared to the 8 hours of the preset
"-1h" key as many times as required, compared to the 8 hours of the preset
32