Tripp-Lite AGSM8208 Serie Manual Del Propietário página 6

Quick Installation
Plug the UPS into an outlet on
1
a dedicated circuit.
NOTE! after you plug the UPS into a live
AC outlet, the UPS (in "Standby" mode)
will automatically charge its batteries,
but will not supply power to its outlets
until it is turned ON.
Plug your equipment into
2
the UPS.*
* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total
VA ratings for all the equipment you connect
exceeds the UPS's Output Capacity. To find your
equipment's VA ratings, look on their
nameplates. If the equipment is listed in amps,
multiply the number of amps by 120 to
determine VA. (Example: 1 amp × 120 = 120
VA). If you are unsure if you have overloaded
the UPS's outlets, see LOAD icon description in
LCD Interface section under Basic Operation.
Turn the UPS ON.
3
Press and hold the
second. The alarm will beep once briefly.
Note: UPS system will function properly upon
initial startup, however, maximum runtime and a
successful self-test will only be accessible after it
has been charged for 24 hours.
17-08-619-933088.indb 6
button for one
A
6
1
2
A
3
9/25/2017 4:46:41 PM