Using Your Microphone; Automatic Power Off - PRESIDENT LIBERTY-MIC Manual Del Usuario

English
Sync the mic
On the mic, press PTT (1) or SYNC/Power On/Off (2). The mic turns on and the LED (4) turns
green when it has synced with the CB.
If you are out of range and move back in range, the mic will automatically re-sync.
Install the belt clip
If you are using the belt clip, slide it onto the belt clip knob on the back of the mic.

USING YOUR MICROPHONE

Transmit
Press PTT (1) located on the side of the mic to transmit.
An error tone sounds if your CB is off, if the wireless microphone is out of range or if the
wireless connection is lost. It will stop when you release PTT (1).
The mic only operates when it is in range. If it is out of range for 2 minutes, it automatically
powers down.
Receive
Release PTT (1) to listen for a response
Note: to hear the reception sound in the wireless microphone, depending on the model of your
CB radio, it may be necessary to connect the audio cord (C). In this case, plug it between the
audio plug (11) of the cradle (B) and EXT. SP. located on the back side of your CB radio. Be
sure to properly adjust the volume of your CB radio.
Increase/Decrease Volume
Press + (7) to increase or − (8) to decrease the volume in 16 step increments. When you reach
the 16th step in either direction, an error tone sounds.
Find a lost mic
1. Press FIND (10) on the cradle.
2. When you locate the mic, press FIND (10) on the cradle again or any key on the mic.
3. The tone times out after 1 minute.

AUTOMATIC POWER OFF

When you turn off the car, the CB is also turned off. If the wireless mic has not been turned
off, press SYNC/Power On/Off (2) to turn it off; otherwise, it will automatically power off after
2 minutes.
The wireless mic will also power off if the mic is out of range for 2 minutes.
TURN OFF ALL FEATURES EXCEPT CHARGING
1. While the battery pack charges in the mic, press and hold SYNC/Power On/Off (2) for about
5 seconds.
2. The mic beeps.
3. After the battery is charged, the LED alternately flashes orange and green.
There are three methods to turn the features back on. You can press SYNC/Power On/Off (2) or
you can press PTT (1). You can also disconnect the mini-USB cable (3), and then reconnect it.
- 15 -