Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Cleaning (continued)
□
Clean the pump rotor approximately once a month. A good
indication that the rotor needs to be cleaned is if the water
flow rate drops. To clean the rotor and associated parts:
1.
Switch off and unplug the pump.
2.
Remove the pump from the water reservoir and
disconnect the flexible hose from the pump outlet (1).
3.
Remove the filtering cover (2) and pressure-casing
(3) from the front of the pump body.
Clean the rotor (4) and housing (5) in clean water
4.
using cotton balls.
Troubleshooting
CAUTION: Running the pump without enough water can
damage the pump.
Problem
The pump will not run.
Specifications
MZ20450DA PUMP
Model No.
Operating Voltage
Frequency
Current
Power consumption (Watts)
Delivery head
Delivery
Maximum submersion
Possible Cause
□
The circuit breaker is faulty.
□
The outlet is faulty.
□
There is not enough water in the fountain.
□
The water flow is low.
□
The pump is clogged.
□
The fountain is clogged.
□
The pump is air locked.
MZ20450DA PUMP
120 V
60 HZ
0.1 A
7.0 W
3.27 ft. (1 m)
450L/h
118G/h
3.0 ft. (0.9 m)
5.
Reassemble the pump, reconnect the flexible hose to
the pump outlet (1), and place the pump back into the
reservoir.
3
CAUTION: Excessive weight or pressure on any of the
fountain sections may cause it to fall. Keep pets,
children, or anyone from sitting, leaning, or climbing on
any of the fountain components.
Solution
□
Verify the circuit breaker is functioning correctly.
□
Plug the pump into a different GFCI outlet.
□
Add water to the water reservoir in the bottom of the
fountain.
□
Adjust the water flow control slider to increase the
water flow.
□
Check the pump intake and discharge for leaves and
debris.
□
Check the fountain hose for kinks and obstructions.
□
Unplug and plug the pump several times.
6
1
5
4
2
Publicidad
