Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
STEP #1
• Assemble the central body with the front and rear tubes as shown. Use
the plastic and metal spacers specified with the front and rear tube.
• Attach each tube to the body using (2) ¼" metal spacers, (2) 3/8" flat
washers, (2) 3/8" lock washer0s and (2) 3/8" hex bolts per side.
• Do not fully tighten bolts, leave loose for final adjustments.
STEP #2
• Assemble the Lateral bodies with the
front and rear tubes as shown. Use the
plastic and metal spacers specified
with the front and rear tube.
• Attach each tube to the body using (2)
¼" metal spacers, (2) 3/8" flat
washers, (2) 3/8" lock washers and
(2) 3/8" hex bolts per side.
• Do not fully tighten bolts, leave loose
for final adjustments.
REV.01
© 2016 Go Rhino Products. All rights reserved
4
Publicidad
