Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
!
•
•
•
Anti-Tip Device
WARNING
!
If your freezer is not located under a counter top (free
standing), you must use an anti-tip device installed as
per these instructions. If the freezer is removed from
its location for any reason, make sure that the device
is properly engaged with the anti-tip bracket when
you push the freezer back into the original location. If
the device is not properly engaged, there is a risk of
the freezer tipping over, with the potential for property
damage or personal injury.
NOTE
If installing on a concrete floor, concrete fasteners are
required, (not included with the anti-tip kit).
CAUTION
!
Any finished flooring should be protected with appropriate
material to avoid damage when moving the unit.
Floor Mount Installation
The anti-tip bracket is to be located on the floor in the left or
right rear corner of the freezer as shown in Figure 7.
INSTALLING THE ANTI TIP DEVICE
FOR FREESTANDING INSTALLATIONS
ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
FOLLOW THE INSTRUC-
TIONS BELOW
Anti-Tip
Bracket
Leveling Leg
Bottom View of
21
⁄
"
1
2
(54.6 cm)
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the freezer. Slide it into
place, being careful not to damage the floor, leaving 1" (2.5
cm) of clearance from the rear wall to allow room for the
anti-tip bracket.
2) Raise the rear leveling legs approximately
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the freezer is in the desired location, then
mark on the floor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the floor marking the front corner
of the cabinet, excluding the door. Slide the freezer out of
the way. From the temporary line extend the sidewall line
back 21
⁄
" (54.6 cm) as shown in Figure 8.
1
2
4) Align the anti-tip bracket to the marks on the floor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
⁄
" (54.6 cm) line (Rear of cabinet
1
2
line).
5) Fasten the anti-tip bracket to the floor using the supplied
screw. (See Figure 8).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
6
Freezer
Front of cabinet
Figure 7
⁄
" (6 mm) to
1
4
Publicidad
