GE JVM1950 Intrucciones De Instalación página 7

Installation Instructions
TOOLS YOU WILL NEED
# 1 and #2 Phillips
screwdriver
Tinsnips (for cutting
damper, if required)
Gloves
Safety goggles
Pencil
Ruler or tape
measure and
ht edge
Scissors (to cut
template, if necessary)
Saw(saber,hole or keyhole)
Electricdrill with _d', 7/Ld',
½" and %" drill bits
Stud finder
or
I
Hammer(optional)
Level
Carpenter square
(optional)
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed bottom
cabinet installations only)
Duct and masking
tape
MOUNTING SPACE
13" max.
66" or I
more from /
the floor to
the
the
to°Je
r
........ Bottom edge of
cabinet needs to
be 30" or more
from the cooking
surface
Backsplash
NOTES:
• The space between the cabinets must be 30" wide
and free of obstructions.
• If the space between the cabinets is greater than
30", a Filler Panel Kit may be used to fill in the gap
between the oven and the cabinets. Your Owner's
Manual contains the kit number for your model.
• This oven is for installation over ranges up to
36" wide.
• If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions
on the top cabinet template for power cord
clearance.
• Maximum cabinet depth above and beside the unit
is 13".
• For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the
vent.
• The product should not be installed over any
cooktop or range with a combined BTU greater
than 66,000 BTU.