ProFlow PF-SOF1-SIM Instrucciones De Instalación página 12

HOLIDAY MODE
It is possible to put the appliance in holiday mode; this will
prevent automatic regeneration from taking place, yet will
ensure the appliance is automatically regenerated at the end
of the holiday cycle.
1. Press the scroll button repeatedly until the display
shows:
Holiday: OFF
Press the up or down

holiday mode by setting the number of full days away
from home, or deactivate the holiday mode (OFF).
Once the control panel is back in service mode, the display
will show:
8:01 Holiday

The holiday mode is automatically cancelled when a
regeneration is manually initiated!
EN - English
ELECTRONIC CONTROL PANEL
button to activate the
Page 12
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll button and hold it for 2 sec until the
display shows:
Language:English
Press the up or down

language.
2. Press the scroll button again; the display will show
(does not apply to Duplex Alternating!):
Set time:
Press the up or down

day.
3. Press the scroll button again; the display will show:
HardUnit:
Press the up or down

measure for water hardness. Make sure it is identical
to the unit of measure of the water hardness test kit
or water analysis report that is used to determine the
hardness of the incoming untreated water!
4. Press the scroll button again; the display will show:
Set Hardn: XX °f
Press the up or down

of the incoming untreated water.
5. Press the scroll button again; the display will show:
Exit
Press the up or down

into the NOVRAM® and exit the programming mode.
button to set the
8:01
button to set the time of
°f
button to set the unit of
button to set the hardness
button to save the settings