Installation Instructions - Cooper Lighting MSLED100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.
Remove the old batteries by hand. Insert new batteries making sure that you
observe the proper polarity orientation between batteries and battery
charger/holder.
5.
Replace the battery cover making sure that the rubber gasket in the grove of
the battery cover is still in place and that no wires have been pinched.
6.
Do NOT move switch to the ON position until batteries are fully charged.
Allow solar panel to receive four (4) full days of sunlight with the switch in the
OFF position before turning fixture ON, or in AUTO mode.
7.
Hang the fixture back on the mounting plate and rotate key to the locked
position for the charging period.

INSTALLATION INSTRUCTIONS

Note: Your fixture is supplied with a pre-installed long life (non replaceable) LED bulbs.
1.
Locate area in which you would like to install your light fixture.
Note: For fixture to operate properly, the solar panel must be located in an area that
will receive the maximum amount of sunlight and is free from obstructions.
2.
Drill two holes on wall where you want the light to be mounted on and put the
plastic plugs into the holes. Then attach the mounting plate with the
mounting screws (Fig. 2).
3.
Hang the light on the mounting plate and lock
it by turning the key. Remove the key and
keep it for future use (Fig. 3).
4.
Allow fixture to receive four full days of
sunlight before turning fixture to the ON
position.
HOW TO OPERATE YOUR FIXTURE
1.
After fixture has received four (4) full days of sunlight, turn the switch on the
back of the fixture to the AUTO position.
2.
Mount the light in a place where it can receive the maximum DIRECT SUNLIGHT
in the daytime. The inside batteries are charged by a solar cell. The more direct
sun light the solar cell received in the daytime, the longer the light will run. It is
better to charge the solar cell in the sunlight for up to 4 days before switching it
ON, so that the light can work with a full charge.
Call for customer service and/or missing or damaged parts (800-334-6871)
4
Fig. 2
Fig. 3

Publicidad

Tabla de contenido
loading

Tabla de contenido