6. Remove the Filter Chamber Cover and the filter chamber rubber gasket,and then take out the filter cartridge.
7. Clean the filter cartridge with a garden hose using a direct powerful
waterspray.
8. If the filter cartridge cannot be cleaned effectively in this manner, it is time to replace it with a new cartridge.
9. Your clean (or new) cartridge can be put back into the filter chamber and you can refer to the installation instruction on
page 3 to re-assemble the filter pump unit.
GENERAL MAINTENANCE
1. To avoid dangerous or fatal electrical shock hazard.always disconnect power to the unit before attempting to clean
pump.
2. There is no need for any regular mechanical maintenance of the pump unit.(Do not attempt to disassemble the pump
motor at any time).
3. If necessary ,clean outside of pump with a mild detergent and water, rinsing off with a hose.
4. There is no need for the use of any lubricants on the pump.
5. Do not use solvents clean the filter cartridge,as they will cause damage to the plastic components inside the pump.
4