VEVOR SFC18100S Manual De Instrucciones página 8

of the coffee maker pot.
IMPORTANT: If the perk tube washer does not move freely or is not seated
properly in the perk well, the coffee maker will not make coffee or the
coffee will be weak.
7.Place the cover on the coffee maker and push it down firmly.
8.Unwrap the power cord from the power base. Then set the coffee maker
pot on the power base and plug into a standard 120VAC wall outlet. Press
the ON/OFF switch down to begin heating. Never heat without water or
liquid coffee in the pot.
Note: During the initial uses, you may notice an odor or smoking as the
manufacturing residue burns off.
9.You will hear the unit begin to perk within 40 seconds of turning the unit
on. The signal light comes on automatically when the coffee is ready. To
serve coffee, simply lift the pot off the base.
CAUTION! Use proper precautions to prevent the risk of burns. Do not
touch the coffee maker's hot surfaces. While in use, the coffee maker parts,
coffee grounds, and coffee may be hot and scalding may occur. After
serving, place the pot back on the power base to keep the remaining coffee
warm. Be sure the base is plugged in and the pot is turned on.
10.When the pot is empty or you no longer want to keep the coffee warm,
turn the pot off and unplug the base from the wall outlet.
CAUTION! The coffee maker parts, coffee grounds, and remaining coffee
may still be hot. To prevent burns, allow to cool before washing the unit.
Care and Cleaning
1.Allow the coffee maker to cool before cleaning.
2.Hold onto the coffee maker handle with one hand. Position your other
hand so that the heel is resting on the cover on the spout side of the coffee
- 6 -