NICREW HyperReef Manual De Instrucciones página 5

English English
Installa�on
• Place the power supply in a dry ven�lated area. Include a "drip loop".
• Assemble the tank mount as instructed (fig. 2).
• Mount on the rear wall of the tank.
NOTE:
• The light fixture must be fastened securely so that it cannot accidentally
be dislodged from its moun�ng.
• The top surface and sides must have unrestricted airflow for correct
heat dissipa�on.
• Moun�ng the light a minimum of 6 inches (15 cm) above the surface
of the water is recommended.
For Hanging Op�on
Screw hanging kit into the center hole and secure the hanging wire to
the ceiling or other mount.
NOTE:
The higher you hang your light over the water, the wider the light
spread - but the lower the light intensity. Wider and/or deeper tanks
may require hanging more than one LED light in order to provide
sufficient light coverage.
(fig. 2)
HyperReef 50