Publicidad
Idiomas disponibles
Idiomas disponibles
Network Settings
After you connect your home network to the TV, follow the steps below to enter the Network & Internet menu.
1. Press
on the remote control to display the dashboard menu.
2. Select
(Settings) and press OK to enter the settings menu.
3. Press Up/Down to select Network & Internet, then press OK to enter the submenu and follow the on-screen
guidance to set up your network.
TV Buttons
- Power button
If the batteries in your remote control are run down, you can use the button on your TV set.
The model has only one
controller.
You can turn on the TV by pressing the
While the TV is on, press the
the multi-function menu, please refer to the figure below.
CH+
Standby
Tips: Short click to change, long click to select.
• Press to move the highlight to the next function selection
• Press and hold the button for more than 2 seconds to confirm your selection.
Note:
- The
button is located at the bottom of the TV or at the bottom left of the TV back case, depending on the
model.
- You can follow the on-screen guide to operate. Figures and illustrations are provided for reference only and may
vary depending on the model.
ON
- MIC switch
OFF
The MIC switch is located next to the power button. If you want to use the feature of hands-free TV voice control,
turn on the switch.
Initial Setup
The first time you switch the set on, the
process. Follow the on-screen instructions to finish the initial setup process such as selecting the language, pairing
your remote, connecting to the network, and more. During each step, either make a choice or skip the step. If you
skip a step, you can perform the setup later from the settings menu.
Notes:
- It's recommended to select Set up Google TV and finish its setup to enjoy more features during the initial setup
process. If you have finished basic TV's setup, you can reaccess Google TV by pressing
(Settings) > Set up Google TV and pressing OK to confirm.
selecting
- When you pair your remote, keep the remote control and TV within 1 meter, and follow the on-screen guide for
pairing. After finishing pairing the remote, you can use the Google Assistant button. If you skip remote pairing, you
will be prompted to pair the remote with the TV again when you use the Google Assistant button for the first time.
All manuals and user guides at all-guides.com
button. It may work just as Standby/Quit standby button, or as a multi-function
button on the TV set.
button to display the multi-function menu. For more information about how to use
CH-
Volume+
Volume-
Welcome wizard
Source
OK
appears, which guides you through the initial setup
11
Getting Started
on the remote control,
Publicidad
