Publicidad
Idiomas disponibles
Idiomas disponibles
Recommended Installation Spacing
The following clearances are recommended for
the Styler. Although the Styler has been tested
3
for clearances of 1
/
inch (3 cm) on the sides
16
and rear, recommended clearances should be
considered for the following reasons:
Ÿ Additional space should be considered for
ease of installation and servicing.
Ÿ Additional space might be required for
wall, door and floor moldings.
Ÿ Additional space should be considered
on all sides of the Styler to reduce noise
transfer.
Ÿ Additional laundry appliance spacing
should also be considered.
Installation Spacing for Recessed Area or Closet Installation
There should be at least a little space around the Styler (or any other appliance) to avoid contact with
walls, furniture, or other appliances during operation. Allow a minimum of 1
of the Styler to avoid increased noise or damage.
Ÿ For closet installation, with a door,
minimum ventilation openings in the
top and bottom of the door are required.
Louvered doors with equivalent ventilation
openings are acceptable.
Closet Ventilation Requirements
Closets with doors must have both an upper and
lower vent to prevent heat and moisture buildup
in the closet. One upper vent opening with a
minimum opening of 48 sq. in. (310 cm
be installed no lower than 6 feet above the floor.
One lower vent opening with a minimum opening
2
of 24 sq. in. (155 cm
) must be installed no more
than one foot above the floor. One example
shown uses vent grilles in the door.
3"
(7.6 cm)
Vent
48 sq. in.
(310 sq. cm)
Vent
24 sq. in.
(155 sq. cm)
(7.6 cm)
closet door vent
requirements
2
) must
in.
in.
3"
7 3/4 in.
(20 cm)
2 in.
(5 cm)
18 in. (46 cm)
in front
3
/
inch (3 cm) on all sides
16
Ÿ Minimum vent opening for built-in
installation is 31 ½ sq. in. (200 cm
Built-In Installation
Wall
10 in. (250mm)
18 in. (455mm)
15.75 in. (400 mm)
2 in. (50 mm)
73.8 in. (1,875 mm)
74.4 in. (1,
18 in. (455 mm)
24.8 in. (630 mm)
19 in. (485 mm)
INSTALLATION
2 in.
(5 cm)
2
).
②
Ceiling
2 in. (50 mm)
①
1 in. (25 mm)
1
/
in. (30 mm)
3
16
8
1
/
in. (30 mm)
3
16
15
Publicidad
