Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
No sound (The batteries of microphone have already been installed,
but one of the microphone has on sound.)
Please turn off the handheld microphone or bodypack microphone
which can work normally, and you will find that the RF light on the
receiver will disappear. Then follow the steps below to pair the no sound
one with the receiver.
1. Make sure that the receiver and HANDHELD microphone are turned
OFF. Or Make sure that the receiver is OFF and the BODYPACK micro-
phone is on.
2. Open the battery case of handheld mic or bodypack mic and install
the batteries.
3. Make sure that the handheld microphone is OFF, press and hold the
HI/LO button and the power button simultaneously, do not release them,
until the handheld microphone screen flashes quickly, then release two
buttons simultaneously. Or make sure the bodypack mic is on, long press
the SET button until the bodypack screen flashes quickly, then release
the SET button.
4. Turn on the receiver's power button, wait for 5 seconds or so, then
press the HI/LO button on the handheld microphone or SET button on
the bodypack once, until the handheld microphone screen or bodypack
screen becomes steady and no longer flashes, the RF light on the
receiver turns steady, indicating that the pairing is successful.
5. Tum off the handheld microphone, then tighten the microphone tail
tube. Pairing is now completed.
Received signal with noise or interference
Change to other channels;
Check if receiving distance exceeds the maximum range.
Microphone cannot be tumed on
Check if batteries are installed reversely;
Change to new batteries.
11
Publicidad
