Publicidad
Idiomas disponibles
Idiomas disponibles
EN
(Original instructions)
CROSSBACK GLOW
CROSSBACK DIGITAL FLEX
Stick vacuum cleaner
DESCRIPTION
A Accesories:
A1 Lance and multiuse brush
A3 Extralong lance
B Extension tube/ Flexible extension tube (*)
C Power supply
D Motorized turbobrush Helix
E Dust tank filter
F Battery indicator
G ON/OFF button
H Body
I Dust tank
J Lithium batteries
K Detachable batteries button
L Wall bracket
M Button to open the lower lid of the tank
N Tank release button
O Speed selector button.
(*) Includes in model Crossback Digital Flex
If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
USE AND CARE
Do not use the appliance if the parts or
accessories are not properly fitted.
Do not use the appliance if the accessories
or consumables attached to it are defective.
Replace them immediately.
Do not use the appliance to gather up water or
any other liquid.
Do not use the appliance if the on/off switch
does not work.
Respect the MAX level indicator.
Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
Do not work on areas where there are metal
objects, such as nails and/or screws.
Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
Do not open the battery/ies under any
circumstances whatsoever.
The battery/ies should be stored at a
temperature of below 40ºC.
Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
Do not use the appliance on any part of the
body of a person or animal.
Do not use the appliance with pets or animals.
Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
Use the device only with the battery/ies for
which has been specifically designed. The
use of any other battery/ies s can cause an
explosion or fire hazard.
INSTALLATION
Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET
The appliance has a charging base (K) which
must be fixed to the wall.
Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive...
Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
Fit the appliance into the wall support.
CHARGING THE BATTERY
Caution: A new battery is not fully charged
and must therefore be charged before the
appliance is used for the first time.
Charge the battery at an atmospheric
temperature of between 4 and 40ºC.
A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
Approximately 4 to 5 hours are needed for
a complete charge of the battery. Never
attempt to over-charge the battery (although
it is recommended that the first charge of the
battery be of 6 hours in duration).
The pilot light will come on to indicate that the
charger is charging the battery.
When the battery is charged disconnect the
charger from the mains supply.
NB: Do not use the appliance while it is
connected to the charger.
Publicidad
