Sharp PS-921 Manual Del Usuario página 6

6
• When you will power off one speaker in Duo Mode, both speakers will
power off.
• When you Power on the speakers, they need to be turned on individu-
ally.
• When both speakers are powered on Duo Mode will automatically
reconnect and you will hear "Duo Mode connected".
• To disconnect Duo Mode press and hold SOURCE button on the secon-
dary speaker until you hear "Duo Mode disconnected"
NOTES:
ū It takes up to 1 minute to connect to Duo Mode.
ū When you enjoy Duo Mode, Multi phone pairing is not supported. The
primary speaker connects only one Bluetooth device.
ū In Duo Mode, you can connect to only the primary speaker with the
Bluetooth device.
ū To change the Bluetooth device in Duo Mode, press and hold
ry unit for 3 seconds to disconnect current Bluetooth device and connect to
the desired Bluetooth device.
ū When you connect a Bluetooth device (iOS device etc.) to this unit or operate
the device, the volume level can be synchronized between each device.
ū When in Duo Mode, the functions of
synchronized with two speakers.
ū In Duo Mode, make the distance between the speakers as close as possible
each other.
ū Depending on network environment, the Duo Mode may not work well.
ū When the Duo Mode is entered, some mobile phones (ex. AptX HD supported
devices) play music after a brief pause.
ū Some mobile phones might not play music properly when you try to connect
Duo Mode during playback.
ū Reset the Duo Mode connection: Disconnect by long press the SOURCE
button on the secondary speaker until you hear '' Duo Mode disconnected'' .
Connection is reset.
Listening to Music from External Device
The PS-921 can be used to listen to audio from external devices.
1. Connect an auxiliary audio device to the unit through the 3.5mm
audio input.
2. Press the SOURCE button to switch to AUX source. The blue light
flashes slowly in Aux mode.
3.
Play and control music on the connected audio device, and use the
and buttons on the unit to adjust the volume.
USB Playback and Charging functions
The speaker can support USB playback and charging.
1.
Insert the USB drive into the USB slot on the back of the unit.
2. The speaker will enter USB mode automatically.
3. The speaker will start to play songs from the USB immediately.
NOTES:
ū The USB mode only can be entered when a USB device is connected.
ū supports USB devices up to 32GB capacity
ū supported audio format is MP3
4. Mobile devices can be charged via the USB port.
Adjust the Light Effects
1.
Short press the button on the top panel of the unit to change the
flashing mode for the centre light. There are 4 flashing effects:
ū Colours gradually flashing.
ū Dynamic flashing, the lights will flashes with the music.
ū Colour rotating flashing.
ū Monochrome rotating flashing.
2.
Long press (2 sec): changes the side light mode
3. Longer press (4 secs) : switch all the lights off
on prima-
, and buttons will be