Publicidad
Idiomas disponibles
Idiomas disponibles
Protective Features
The Inverter monitors the following conditions:
• Low Battery Voltage
— The inverter will automatically shut down when
Snap-on CTB7185/CTB8185 battery voltage
drops below 16.75 VDC.
• Short Circuit Protection
— The inverter will automatically shut down when
a short circuit occurs.
• Over Current Protection
— The inverter has one 15A fuse. It will be blown
when input current is over 15A. Replace with
identical fuse and use correct battery.
• Over Load Protection
— The inverter only may output 120VAC / 175 W
from its three-prong socket. When the
appliance is plugged in is out of specification,
the buzzer will ring to warn overloading and
the inverter will not output.
Operating Tips
The Inverter should only be operated in location that are:
• DRY - Do not allow water or other liquids to come into
contact with Inverter.
• COOL - Surrounding air temperature should ideally be
32°F(0°C)-140°(40°C). Keep it away from direct sunlight,
when possible.
• WELL VENTILATED - Keep the area surrounding the
Inverter clear to ensure free air circulation around the unit.
Do not place items on or over the Inverter during
operation. It will shut down if its internal temperature gets
too hot. It will auto-reset after it cools down.
• SAFE - Do not use the Inverter near flammable materials
or in any locations that may accumulate flammable
fumes or gases. This is an electrical appliance that can
briefly spark when electrical connections are made or
broken
Storage
• Storage temperature : 32°-104° F (0°-40 °C).
• Store and use the Inverter in a cool, dry place with battery
pack, charger and USB-powered device.
• Avoid locations that are exposed to heating units,
radiators, direct sunlight or excessive humidity or
dampness.
ZCTI8850 Rev. D
Battery Charging
1. Insert the power cord plug into the socket of the
charger.
2. Plug the other end of cord plug into power source
outlet.
3. Insert battery pack into the charger.
— The green light will start flashing. This indicates
the charger is charging the battery pack.
4. The fuel gauge on the battery pack will display the
charge percentage % value status.
— When the battery is 25% charged, one light will
be solid green.
5. When the fast charge is complete all (4) lights on the
battery pack will be solid green indicating battery is
fully charged and charger will indicate solid green
light.
6. If the LED on the right hand side is flashing a yellow
light then the battery pack is either hot or cold. The
charger will not fast charge the battery if it is too hot
or cold. The charger goes into a fast charge mode
when the battery temperature is between 32°F (0°C)
and 113°F (45°C).
7. If the LED on the right hand side is flashing a red light,
the battery pack is faulty and the charger will not
charge the battery.
8. When the fast charge is complete, battery voltage is
detected by the charger and it automatically turns off
to prevent an over-charge and all four lights on the
battery fuel gage will be on and charger will indicate
solid green light
9. The charger has one USB port, its output current is
1.0 A and output voltage is 5 VDC. Do not connect to
an appliance requiring over 1.0 A.
7
Figure 4:
(03/16)
Publicidad
