Nave CADENA 5314770 Manual Del Usuario página 11

Replacing the battery
Charging process
Damage to the product
Make sure that the charging current of the connected mains adapter does not exceed max. 1 A. A higher

charging current for the product to be charged can cause a defect.
Non-compliance with this instruction can cause damage to property.
The solar panel can also be charged with a USB-C cable/DC connection, which is also included in the scope
of delivery.
The light can be operated while charging. When charging, a red indicator light on the back of the solar panel
lights up.
Cleaning and care
Damage to the product
Do not use any solvents for cleaning.

Do not apply pressure to the solar module during cleaning.

Non-compliance with this instruction can cause damage to property.
Use a soft, dry cloth for cleaning.

In case of severe soiling, use a soft and slightly damp cloth to clean the product.

Troubleshooting
If the product does not work despite following the instructions, please check the following points:
Make sure the product is switched on.

Check if the solar module is broken or damaged.

If the lighting duration is short despite optimal sunlight, the battery is depleted and must be replaced. Please use
rechargeable batteries of the same type only, and never use non-rechargeable (primary) batteries.
5314770_Manual_16961_04_V1
NOTE
NOTE
11 / 55
To replace the batteries in the remote control, use
1x CR2025 / 3 V
