Publicidad
Idiomas disponibles
Idiomas disponibles
GB
SAFETY INSTRUCTIONS FOR BATTERIES
• Do not attempt to revive batteries or rechargeable batteries by heating or similar measures. Primary batteries
must not be recharged as this can lead to electrolyte leakage, explosion or fire.
• Do not immerse batteries in water and store them in a dry, cool place, not a damp one.
• Do not throw batteries into a fire, do not open them nor solder or weld them yourself.
• Do not short-circuit batteries.
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• 0,25cm USB charging cable
TECHNICAL DATA
• This product contains a light source of energy efficiency class F
• Output: 5W
• Illuminant: SMD LEDs
• Luminous flux: 500lm
• Light output: 100lm/W
• Colour temperature: 7200K
• Índice de reproducción de colores (Ra/CRI): ≥ 80
• LED service life: 25000h
• Beam angle: 120°
• IP protection class: IP44
• IP protection class in charge state: IP20
• Protection class: III (S4)
• Ambient temperature: -10°C – 50°C
• Dimensions W x H x D: 125 x 95 x 38mm
• Weight: 188g
• Battery: 3,7V DC/ 1200 mAh / 4,5Wh / Lithium ion battery
• USB: Micro IN 5V DC / 1A ; USB „A" OUT 5V DC / max. 2A
USAGE
• Charging: Before (first) use, fully charge the product until the battery indicator lights up completely
(Note: Only charge in a frost-free area!).
• The product has a charging input with a Micro-B type socket. Only use the enclosed USB charging cable, which
can be plugged into a conventional USB power supply unit (socket: type A). Only use tested USB power supply
units with a maximum output voltage of 5V.
• Connect the USB charging cable to the charging input on the product and the USB power supply unit (A3).
• Charging time: 4 hours (depending on the selected USB power supply)
• Running time: 2 hours (500lm) / 4 hours (250lm)
• 1x press: full power (500lm)
• 2x pressing: lowest power (250lm)
• Press three times: Off
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
10
Publicidad
