Polar UA037 Manual De Instrucciones página 6

EN
Operation
Making Ice
Note: Before using for the first time (or
after a period of inactivity), clean the water
tank, ice basket and ice basket shelf. Use
the first ice making cycle to flush out the
system. Discard the water and ice created
from the first cycle.
1. Ensure the door is closed fully before use.
2. Press the Power switch to the On position
[I]. The POWER light illuminates and the
appliance begins the ice making process.
Each ice making cycle takes approximately
25 minutes.
3. When the cubes reach the ice sensor ice
production stops. Production resumes once ice
has been removed from the bin.
4. Press the Power switch to the Off position [O]
at any time to halt the ice making process.
Note: Ensure metal rack is pushed as far
forward as possible against plastic ice
curtain to allow ice to fall.
UV sterilization Function
Featured with the optional UV-C function, the
appliance provides sterilization for the water and
ice cubes.
UV indicator light
Power switch
1. To activate, press the "UV" button once after
the unit is powered on. The UV indicator light
is on and UV sterilization starts.
2. To deactivate, press the "UV" button again.
The UV indicator light is off.
6
UA037_ML_A5_V1_20240118.indb 6 UA037_ML_A5_V1_20240118.indb 6
UV button
Note:
Each time the unit restarts, UV sterilization
function stops by default.
Each time the door is opened, the UV
indicator light will turn off and the
sterilization in the box will be disabled.
After the door closed, the UV indicator will
light up and the sterilization in the box
resumes.
To avoid contamination of ice, please respect
the following instructions:
• Opening the door for long periods can cause a
significant increase of the temperature in the
compartments of the appliance.
• Clean regularly surfaces that can come in
contact with ice and accessible drainage
systems.
• Clean water tanks if they have not been used
for 48h; flush the water system connected to
a water supply if water has not been drawn for
5 days.
• If the refrigerating appliance is left empty for
long periods, switch off, defrost, clean, dry,
and leave the door open to prevent mould
developing within the appliance.
Cleaning, Care &
Maintenance
• Always switch off and disconnect the power
supply before cleaning.
• Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
residues. DO NOT wash the base unit, instead
wipe the exterior with a damp cloth.
• Clean the water filter regularly with a small
brush, particularly in hard water areas. The
water filter is located just inside the water inlet
at the back of the appliance.
• If the Ice Maker is to be left unused for longer
than 24 hours, loosen the drain valve cap and
drain the water from the tank.
• The inner removable parts and water tank
should be cleaned regularly.
2024/1/18 14:38 2024/1/18 14:38