Publicidad
Idiomas disponibles
Idiomas disponibles
Feature Settings
LOCK
Activate:
NOTE: Your remote controls will NOT work when LOCK mode is active however
your keyless entry will still allow access to your garage.
Press and hold the LOCK button for 2 seconds. The command LED will flash as
long as the lock feature is activated and your handheld remote control will not
operate your door at this time.
Deactivate:
Press and hold the LOCK button again for 2 seconds. The command LED will
stop flashing and normal operation will resume.
Command LED
LOCK Button
Warranty
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that it is
free from defect in materials and/or workmanship for a period of 1 year from the date of purchase.
LIGHT
To change the amount of time the garage door opener lights will stay on
(default time is 4-1/2 Minutes):
Press and hold the LOCK button until the garage door opener lights flash.* The
garage door opener lights will then indicate the current light duration by
flashing up to 4 times (see table below).
NUMBER OF TIMES GARAGE DOOR OPENER
LIGHTS FLASH
1
2
3
4
To change the light duration time repeat the steps above until the lights flashes
indicate your desired time frame.
Light Feature
NOTE: Factory setting is on.
This feature will turn on the garage door opener lights when the safety
reversing sensors beam has been broken.
Deactivate:
Start with the garage door opener lights off. Press and hold the LIGHT button
to turn on the light, continue to hold until the light turns off.*
Activate:
Start with the garage door opener lights on. Press and hold the LIGHT button
to turn off the light, continue to hold until the light turns on.*
Command LED
LOCK Button
LIGHT Button
* Approximately 10 seconds
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
4
TIME THE GARAGE DOOR OPENER LIGHT
STAYS ON
1 ½ Minutes
2 ½ Minutes
3 ½ Minutes
4 ½ Minutes
1-800-528-9131
Publicidad
