Publicidad
Idiomas disponibles
Idiomas disponibles
9. Hooking up the keg coupler to the keg: Verify the cou-
pler is in the "OFF" position (see Figure 37a).Align the
lugs on the keg with the corresponding openings on the
keg coupler and turn clockwise until the coupler stops
(about 90°). Push down and twist the top of the coupler
clockwise to allow gas to enter the keg.
Push faucet handle back toward
tower to close the faucet
Figure 36
Lugs
on keg
Figure 37b
USING YOUR BEER DISPENSER
Chain-The chain is fastened and taped
to the top of the interior liner. Remove
the tape and secure the CO
place in the back right corner. Loop
chain around top of tank and connect
16
tank in
2
with "S" hook.
Rotate the top of the coupler coun-
ter clockwise to extend the coupler
to the to the "OFF"position.
Figure 37a
Figure 37
Connect
with "S"
hook
Figure 44a
Coupler
extended
Publicidad
