Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
Keep your hands away from the tool attachment
when the product is in operation.
Note:
* = not included in the scope of delivery!
1. Turn the quick-release chuck (2) anti-clockwise until
the chuck opening (1) is large enough to insert the
tool attachment*.
2. Insert the tool attachment* into the quick-release
chuck (2) as far as possible.
3. Turn the quick-release chuck (2) clockwise to clamp
the tool attachment* tight.
4. To remove the tool attachment* again, untwist the
quick-release chuck (2) and remove the tool attach-
ment*.
8.4
Test run
Note:
Before the first work and after each tool attachment
change, carry out a test run without load. Switch off the
product immediately if the tool attachment runs out of
round, there is considerable vibration or abnormal nois-
es are heard.
1. Before operation, check whether the tool attach-
ment is properly attached, i.e. centred in the quick-
release chuck (2).
2. Screw bits are marked with their dimensions and
shape. If you are unsure, always try out first wheth-
er the bit sits in the screw head without play.
8.5
Gear selection
1. Push the gear selector switch (4) to 1
sponding to a low or high speed selection.
Gear 1 :
Suitable for:
Rotational speed:
Torque:
Gear 2 :
Suitable for:
Rotational speed:
Torque:
8.6
Set direction of rotation
ATTENTION
The direction of rotation switch may only be actuated
when idle.
24 | GB
With the direction of rotation switch, you can select the
direction of rotation of the product (clockwise or anti-
clockwise) and secure the product from being switched
on unintentionally. The arrow on the direction of rotation
switch indicates the working direction.
1. Wait until the product has come to a standstill.
2. Push the direction of rotation switch (10) to the de-
sired position:
3. Switch lock: Put the direction of rotation switch in
the centre position.
8.7
ATTENTION
The torque adjusting ring may only be actuated when
idle.
Note:
A clear ratcheting sound is heard when reaching the
preset torque limit. This noise is caused by the slip
clutch.
Note:
You can preset the maximum torque by turning the
torque adjusting ring (3). There are 25 torque levels + 1
drill level.
1. Select the desired torque by turning the torque ad-
justing ring (3).
2. Start with a lower torque level and increase it as re-
or 2 corre-
quired.
Level 1
0 – 420 rpm
Level
Screwing work
Screws
Low
Drilling
High
8.8
0 – 1500 rpm
The speed can be steplessly controlled by the on/off
Drilling work
switch. The further you press the on/off switch, the
High
higher the speed.
Low
1. To switch on the product, push the on/off switch (9).
2. To switch off, release the on/off switch (9).
If you put the direction of rotation switch (10) in the
centre position, the product is secured from being
switched on.
8.8.1
This product is equipped with an LED work lamp to illu-
minate the immediate work area and improve visibility
in poorly lit environments.
www.scheppach.com
– Clockwise rotation: For drilling and screwing
in screws. Press the direction of rotation switch
to the right.
– Anti-clockwise rotation: To undo screws.
Press the direction of rotation switch to the left.
Adjusting the torque
On/Off switch (9) (Fig. 1)
LED work lamp (8)
Lowest torque
Highest torque
Level 1 - 25
Level
Publicidad
