IARP JOY 30 PRIME Instrucciones De Uso Para El Usuario página 29

9. CLEANING
9.1 OUTER CLEANING
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral soap
1
and water solution.
2 STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry with soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and dry with soft
3
cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable to use
4
ordinary water which can leave a film of calcium on the surface of the glass.
4
1
9.2 INNER CLEANING
For a periodical tank cleaning, proceed as follows:
1. Remove the product and the shelves from refrigerator;
2. Unplug the unit;
3. Before cleaning the tank the inside temperature must be equal to the ambient temperature;
4. Extract the plate, taking care to hold it as horizontal as possible to prevent any dirt from falling into the
compartment below.
5. Wash the plate with water and mild soap, rinse it and carefully dryit with a soft cloth.
6. Clean the area below the plate sucking any dirt and/or remnants with a properly powerful aspirator.
7. Clean the tank, rinse and dry carefully.
8. Clean racks supporting the shelves, by using an air flow.
9. Turn the unit on, and load the product.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
3
4
4
1
Defrosting is executed automatically.
The water generated by the evaporator, collected in a tray, soaks an
absorbent cloth and is dissolved by means of the heat lost by the
cooling system.
Periodically check and clean the tray,removing dust and/or residues,
after extracting the support of the absorbent cloth.
1
4
1
1
-30-