Publicidad
Idiomas disponibles
Idiomas disponibles
completed (see fig. 2 (D))}.
You can fully charge the shaver in
one hour if the battery capacity moni-
tor flashes down to the 20% level or
if the recharge tamp flashes green
(ES7015 and ES7016, see fig. 2 (B)).
A full charge will supply enough
power for about 12 shaves (three
minutes
per shave for a normal
beard).
You can always store your shaver in
the charging adaptor to maintain full
power capacity. This shaver cannot
be overcharged.
Before traveling, charge it fully for 1
hour if you will not be taking the
charging adaptor with you.
Using your shaver
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angie (90°) to your skin (see fig.
3). Start out shaving by applying gen-
tie pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
System outer foil
(see fig. 4)
System outer foil has a slit blade (a)
between two foils (b). They move up
and down independently to follow the
contours of your face.
The slit blade catches
and cuts
longer and lying hairs easily.
For wet shaving
Put a thin layer of shaving foam on
your face which works as a lubricant.
Shaving foam is the most suitable
among many other shaving aids (gel,
soap, cream, etc). Do not put a thick
layer of shaving foam as it may af-
fect the shaver's performance. If the
shaving head is clogged with foam,
simply rinse it under running water.
Using the trimmer
(see fig. 5)
Slide the trimmer switch up to the
erm position until it clicks in.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
Cleaning your shaver
(see fig. 6)
For cleanliness and convenience, we
recommend
that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep your
shaver in good condition while pre-
venting odors or bacteria from devel-
oping, and maintain the cutting per-
formance.
With the system outer foil in place,
apply some hand soap onto the outer
foil.
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the foil frame and clean it
with running water.
Wipe off any. moisture from the
shaver with a dry cloth and remove
the protective cap to allow the sys-
Publicidad
