Ryobi RTS12 Manual Del Operador página 26

To use a jig:
 Position the workpiece flat on the table with the edge
flush against the jig and against the stop.
 Holding the jig handle and using a push block and/or
push stick make the rip cut, see Making a Rip Cut later
in this section.
FEATHERBOARD
A featherboard is a device used to help control the
workpiece by holding it securely against the table or fence.
Featherboards are especially useful when ripping small
workpieces and for completing non-through cuts. The end
is angled with a number of short kerfs to give a friction hold
on the workpiece and locked in place on the table with a
C-clamp. Test to ensure it can resist kickback.
WARNING:
Place the featherboard against the uncut portion of the
workpiece to avoid kickback that could cause serious
personal injury.
Commercially available featherboards can be purchased
for a reasonable price. Many of these featherboards mount
inside the miter slots of the saw and are convenient to mount
and use on your table saw. To make a featherboard, follow
the instructions in the next section.
HOW TO MAKE A FEATHERBOARD
See Figure 29.
The featherboard is an excellent project for the saw. Select
a solid piece of lumber approximately 3/4 in. thick, 2-1/2 in.
wide and 12 in. long. Mark the center of the width on one
end of the stock. Miter the width to 70° (see page 36 for
information on miter cuts). Mark the board from the widest
point at four inches.
Prepare the saw for ripping as discussed on page 34. Set the
rip fence to allow approximately a 1/4 in. "finger" to be cut in
the stock. Feed the stock only to the mark previously made at
4 in. Turn the saw OFF and allow the blade to completely stop
2 1/2 in.
3/4 in.
OPERATION
rotating before removing the stock. Reset the rip fence and
cut spaced rips into the workpiece to allow approximately
1/4 in. fingers and 1/8 in. spaces between the fingers.
HOW TO MOUNT A FEATHERBOARD
See Figure 30.
Completely lower the saw blade. Position the rip fence to
the desired adjustment for the cut to be performed and lock.
Place the workpiece against the fence and over the saw
blade area. Adjust the featherboard to apply resistance to
the workpiece just forward of the blade. Attach C-clamps to
further secure the featherboard to the edge of the saw table.
WARNING:
The featherboard must be installed in front of the blade.
Do not locate the featherboard to the rear of the blade.
Kickback can result from the featherboard pinching
the workpiece and binding the blade in the saw kerf if
positioned improperly. Failure to heed this warning can
result in serious personal injury.
1/4 in.
1/8 in.
12 in.
26 - English
PUSH
BLOCK
FEATHERBOARD
70°
4 in.
PUSH
BEVEL
STICK
LOCKING
LEVER
Fig. 30
Fig. 29