Cardin Elettronica CDRX12 Manual Del Usuario página 10

- fasten the base
5
- wire up the receiver
- seal the wires and the rubber gasket
of IP55;
- hook on the cover
8
- insert the cover holding screw
Installation CDRX12 using an optional cable clamp (fig. 3)
• According to the installation requirements work out the wall mounting points;
- run the cable holding pipe
not exceed a diameter of Ø5 mm);
- using the template located inside the packing, trace the wall fastening points according to the CDRX12
dimensions shown in figure 1;
- remove the cover blocking screw
- using Ø 5 mm bit drill the holes in the marked positions
- fasten the base
3
- using a Philips screwdriver
- insert the cable clamp
- pass the cable (max Ø5 mm) through the cable clamp
- carry out the electrical connections
- pull the cable slightly downwards
- hook on the cover
12
- tighten the plastic nut
grade of IP55.
to the wall using the supplied screws and rawlplugs
following the electrical drawing shown in figure 4;
7
with a layer of silicon in order to guarantee a protection grade
4
, rotate it downwards
and fasten down.
10
to the point at which you intend to affix the receiver (the 4-wire cable must
C
, rotate the cover upwards
1a
to the wall using the supplied screws and rawlplugs
knock out the hole
5
and fasten down using the supplied nut
7
following the diagram as shown in figure 4;
10
;
11
, rotate it downwards
and apply a layer of silicon around the cable in order to guarantee a protection
14
and connect it to the base;
9
1b
;
2
located inside the cover;
6
9
and connect it to the base;
13
10
;
6
and separate it from the base
;
4
;
8
;
1c