RIB SLIDER radar Manual De Instrucciones página 21

OVERVIEW OF SETTINGS
Back
More
PRESETTINGS
RAD: FIELDSIZE
small
IR: IMMUNITY
IR: FREQUENCY
More
Back
Back
More
RAD: IMMUNITY
radar
RAD: DIRECTION
off
RAD: HOLDTIME
0.5 s
RAD: OUTPUT
IR: WIDTH
+
service
IR: NUMBER
mode
IR: PRESENCE TIME
motion
IR: OUTPUT
REDIRECTION
motion
FACTORY RESET
More
Back
ZIP CODE all parameter settings in zipped format
(see application note on ZIP CODE)
ID # unique ID-number
ERROR LOG last 10 errors + day indication
IR: SPOTVIEW
view of spot(s) that trigger detection
IR: C1 ENERG signal amplitude received on curtain 1
IR: C2 ENERG signal amplitude received on curtain 2
0 1 2 3
shopping
critical
standard
street
env.
> > >
< 2.8 m
low
normal
high
Sensors mounted close to each other should have
A
B
a different frequency.
factory value
low >
uni
bi uni
PRM
1 s 2 s 3 s
NO NC
NC
NC
NO
NC
service mode = no IR detection during 15 minutes (maintenance).
1 2
This value excludes conformity of the door system to EN 16005 and DIN 18650.
15 s 30 s 1
min
NC
NO NC
NO
NC NC
motion motion opening output is active in case of:
or and
presence presence
4 5 6 7
factory values for radar immunity, IR immunity, IR number and redirection
increased immunities, 1 curtain
increased immunities, redirection = motion and presence
> > >
> 2.8 m
higher highest normal high
excludes conformity of the door system
according to EN 16005 / DIN 18650 / BS 7036
> > > >
uni uni
bi
PRM
AWAY auto
auto auto
4 s 5 s 6 s 7 s
NO
NO
2 5 10 20 min 60 min infinite
min min min
NO
NO
0 motion detection
1 motion or presence detection
2 motion and presence detection
POWERSUPPLY
OPERATINGTIME power duration since first startup
RESET LOG
PASSWORD
LANGUAGE
ADMIN
8 9
> large
For conformity to EN 16005 or DIN 18650 at a
mounting height of 2.8 or more, use values 6 and 7.
For conformity to BS 7036 at a mounting height of
2.2 m or more, use values 6 and 7.
high
>
PRM: for persons with reduced mobility
AWAY: unidirectional motion away from sensor
auto: automatic adaptation of field size (small shops)
8 s 9 s
NO: normally open
NC: normally closed
Always additionally adjust the
arrow position on the
sensor with a screwdriver.
min. value for DIN18650: 1 min
min. value for EN16005: 30 s
NO: normally open
NC: normally closed
full partial partial: outputs are
not reset
reset reset
supply voltage at power connector
delete all saved errors
LCD password
(0000= no password)
language of LCD-menu
enter code to access admin mode
5