Worx HYDROSHOT WG620E Serie Manual Original página 16

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
This tool is intended for cleaning and watering.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the battery
pack with battery indicator light.
Charging the battery pack
More details can be found in charger's
manual
ASSEMBLY
Way 1:
Attaching pressure cleaning lance to the
power nozzle
NOTE: When attaching, align the two
projections on the lance with the grooves
16
of the power nozzle as shown in Fig. B1.
Way 2:
Attaching short lance to the machine
NOTE: When attaching, align the two
projections on the lance with the grooves
of the machine as shown in Fig. B2.
Way 3:
Attaching extension lance to the power
nozzle, then attaching the short lance to
the extension lance
NOTE: When attaching, align the two
projections as shown in Fig. B3 and Fig.
B4.
Attaching the spray nozzle
NOTE: when attaching, rotate the nozzle
left and right to make sure the nozzle
fully seated into position and gently
pulling it to make sure it is locked into
position securely.
Attaching the hose to the power nozzle
and use it with foldable water bucket or
throw it into other water sources
NOTE: After the hose is attached, check
the connection by gently pulling upon
the hose. It should not be pulled off.
2 in 1: Portable Power Cleaner/Water Sprayer
Attaching your own water hose (optional)
1. Remove the hose adapter
2. Attach the home garden hose with
suitable connectors
NOTE: Besides the hose supplied, you
can also connect the power nozzle
to your own water hose with suitable
connectors, but water leakage may occur.
NOTE: Check whether the filter screen
is missing before retightening the
FIGURE
hose adapter as shown in Fig. E1 and
Fig. E2. When retightening the quick
hose adapter, please tighten securely.
See Fig. A1
Otherwise, it may not draw any water for
proper operation.
See Fig. A2
OPERATION
WARNING: The supplied battery
See Fig. A3
is not waterproof. To avoid risk
of battery failure, protect the battery
from water exposure during use.
See Fig. A4
Store the tool and battery in a dry
place after use.
Start
NOTE: At the first use or after long-
term storage, it is recommended to
attach the tap or inject water into
See Fig. B1
the hose adapter with the machine
turned on, so as to empty the air. Do
not start working until the water
goes up along the hose and sprays
out.
Selecting the nozzle pattern
See Fig. B2
NOTE: Choose a suitable nozzle pattern
according to your work. Spray
patterns 0
applicable for cleaning, and the spray
pattern with the symbol
suitable for watering.
See Fig. B3,
WARNING: Do not shift the
B4
nozzle pattern when the tool is
powered on.
Cleaning
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
See Fig. C
(Including window cleaning liquids,
plant foods, or fertilizers etc.)
NOTE: For proper maintenance after
using with sea water, the product should
be rinsed by fresh water.
Watering
See Fig. D1,
D2
, 15 , 25 and 40 are
0 0 0 0
is best
See Fig. E1,
E2, E3
See Fig.
F1,F2,F3
See Fig. G
See Fig. H, I
See Fig. J
EN