Black and Decker BD17203 Manual De Instrucciones página 10

5 . Remove the 3 preassembled M5 nuts from
the upper supporters (K). Slide the 3 upper
supporters into the slots at the top of the
burner (E). Once fully inserted, secure
the upper supporters into the burner by
replacing the M5 nuts that were removed at
the beginning of this step.
Note: Be sure that the hooks on the upper
supporters (K) are facing upwards.
K
6 . Remove the 3 preassembled screws from the
top of the burner (E). Attach the glass tube
ring (D) to the top of the burner (E) using
the 3 screws removed at the beginning of
this step. Be sure to fully tighten.
E
D
E
7 . Attach upper radiation screen (B) to lower
radiation screen (C) using 3 M8x75 studs (II)
and 3 M8 nuts (JJ).
JJ
II
8 . Attach reflector (A) to radiation screen
assembly using 3 M6x60 studs (KK), 3 M6
washers (MM) and 3 M6 cap nuts (LL).
B
C
10