Descargar Imprimir esta página

Black and Decker BD17203 Manual De Instrucciones página 13

Calentador de área de inducción rápida

Publicidad

Idiomas disponibles

Idiomas disponibles

a chemical burn occurs or if irritation persists,
seek medical attention. Dispose according to
Local, State, or Federal regulations.
• Battery is to be inserted based on
instructions provided in this manual
• NEVER dispose of batteries in fire, as they
may leak and explode.
• Promptly remove exhausted batteries from
product.
• Remove batteries before extended storage.
To Light
1 . Unscrew the ignition button on the burner
to see if the battery (I) has already been
placed inside. If the battery (I) is not already
within the ignition button on the burner,
please place the battery (I) into the ignition
button slot. Make sure the positive side of the
battery faces outwards. Screw the ignition
button over the battery tightly.
I
2 . Make sure the ignition control knob is
turned to the off position. Connect propane
gas tank and slowly open the valve on
the propane gas tank by turning the knob
counterclockwise.
3 . Press in and turn the ignition control knob to
the 'pilot' position; hold down for 1 minute.
4 . Push the ignition button, while still holding
down control knob down, to generate a
spark.
5 . Check to see if there is a pilot light through
the glass tube (G). If there is, turn the control
knob to the low position.
6 . For maximum fame height and heat output,
turn the control knob to the high position.
To Extinguish
1 . Push and turn the ignition control knob
clockwise to the "off" position.
2 . Turn the propane gas tank valve on the gas
tank to close the gas supply and disconnect
the propane gas tank
WARNING:
If the lighting instructions are
not followed directly a fire or explosion may
occur resulting in property damage, personal
injury or death.
MAINTENANCE
WARNING
Before performing any
maintenance always disconnect propane gas tank.
• Keeping the heating item free and clear from
combustible materials.
• Visually inspect burner for obstructions and
keep tank enclosure free and clear from
debris.
• Use a soft brush to get rid of the mild
stains, loose dirt and soil after the burner is
completely cooled down. Wipe down with a
soft cloth.
• Harsh weather conditions may cause
stubborn stains, discoloration and possibly
rust pitting.
• Permanent damage may occur if powder
or solvent comes in contact with painted or
plastic components on this heating unit.
• Keep the heating unit stored away from
direct sunlight.
• If storing this unit inside, disconnect the
propane gas tank from the gas valve.
• Not using manufacturer approved or
supplied parts/accessories may result in a
defective condition and void the warranty of
this heating unit.
• Always place lid (if applicable) or protective
cover on heating item when not in use.
13

Publicidad

loading