11 TECHNICAL DATA
Rated voltage
Rated frequency
Rated power
Rotation speed
Max. diameter
Protection class
Int. protection degrees
Collect box
:
Note
1.
The P40 indicates a load profile of 4 min load and 6 min idle time. For practical
application, continuous operation is permitted.
2.
The Max Cutting Diameter depends on the hardness of the wood.
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
13 CLEANING AND MAINTENANCE
Before commencing cleaning and maintenance procedures, make sure the garden shredder is
switched off and disconnected from the mains supply. Always wear sturdy leather gloves when
cleaning the cutter blades.
▪
To ensure the best performance from the garden shredder, it must be kept clean.
▪
Always clean the garden shredder immediately after use.
▪
Do not allow material to become dry and hard on any of the garden shredder surfaces.
This will directly affect the shredding performance.
▪
Make sure that the inlet chute and the discharge chute are kept clean and clear of all
waste material.
▪
Make sure that all nuts, bolts and screws are tight and secure.
▪
Always have any damaged or worn parts repaired, or replaced by qualified personnel.
▪
Do not use detergents or solvents as these could cause irreparable damage to your
machine. Chemicals can destroy the plastic parts.
▪
Oil the drum every 4
CAUTION! Do not over tighten the anvil plate adjustment knob and cut
excessive aluminium off of the plate, as this will reduce the life of your
shredder.
Have your garden shredder inspected and maintained by qualified service
personnel. Do not attempt to repair the machine unless you are qualified to
do so.
Copyright © 2023 VARO
th
th
or 5
(use BIO-degradable oil to protect environment).
P a g e
POWXG6462
230-240 V
50 Hz
2800W (P40)
-1
42min
45mm
Class I
IPX4
60l
75dB(A)
86dB(A)
| 12
EN
www.varo.com