Corby Milton Manual De Instrucciones página 10

INSTALLATION (WALL-MOUNTED)
1.
Mark the wall with a
pencil to indicate the
location of the bracket.
4.
Hang the base unit on the bracket. Align the product
with a spirit level and mark with a pencil through the
bottom hole.
7.
Re-hang the base unit and screw the large screw into
the hole. Cover the screw hole with the screw cap.
1 0
2.
Use a drill and 6mm
masonary bit to drill a
hole on the marked point.
3.
Insert a wall plug into the
hole and secure the
bracket as shown using
a small screw.
5.
Unhook the base unit
and drill into the wall at
the marked point.
6.
Insert a wall plug into the
hole.