Collect the pumped out oil only
in approved oil containers. Do
not pump different types of oil
into the same container.
Disconnect the appliance
from the battery terminals
immediately after operation.
Using the appliance for
extended periods of time can
completely discharge vehicle
battery.
Do not carry the appliance by
the connecting cables or the
hoses. Keep the connecting
cables and hoses away from
hot parts of the vehicle or sharp
edges.
Store the appliance and the
used oil in a dry place and out
of reach of children.
Dispose of used oil and soaked
rags properly (see "Disposal").
In order to protect the
environment, do not let oils drain
into the ground or household
drains.
Never use a damaged
appliance! Disconnect the
appliance from the vehicle
and contact your retailer if it is
damaged.
Never use accessories which
are not recommended by the
manufacturer. They could pose
a safety risk to the user and
might damage the appliance.
Only use original parts and
accessories.
This product has been classified
as IPX4 and is protected against
splashing water from any
direction. Do not immerse in
water.
m CAUTION! Do not immerse the
electrical parts of the appliance
in water or other liquids. Never
hold the appliance under
running water.
To prevent damage, let
the appliance cool for at
least 10 minutes after
every 30 minutes of
continuous operation.
Getting started
Attaching the hoses
1. Remove the protective caps
2. Straighten the suction hose (Ø 6 mm)
[
9 ]
(Transparent)
and the drain hose
(Ø 12 mm) (Grey)
3. Put the hose clamp
suction hose (Ø 6 mm) (Transparent)
the suction hose end onto the suction hose
8 ]
[
connector
. Fasten the hose clamp
Slotted screwdriver or SW6 wrench).
4. Put the hose clamp
drain hose (Ø 12 mm) (Grey)
end of the drain hose onto the drain hose
6 ]
[
connector
. Fasten the hose clamp
Slotted screwdriver or SW6 wrench).
[
7 ]
(fig. A).
[
]
.
[
]
to the end of the
9 ]
[
. Plug
[
]
(Tool:
[
]
to the end of the
[
]
. Plug the
[
]
(Tool:
GB/IE
21