Wagan Tech 7402 Manual De Usuario página 7

3. Check polarity of battery posts. POSITIVE (POS, P, +) and NEGATIVE (NEG,
N, –).
4. Determine which post of battery is grounded (connected) to the chassis.
If negative post is grounded to chassis (as in most vehicles), connect
POSITIVE (RED) clamp from battery charger to POSITIVE (P0S, P, +)
ungrounded post of battery. Connect NEGATIVE (BLACK) clamp to vehicle
chassis or engine block away from battery. Do not connect clamp to
carburetor, fuel lines, or sheet-metal body parts. Connect to heavy gauge
metal part of the frame or engine block.
If positive post is grounded to the chassis, connect NEGATIVE (BLACK)
clamp from battery charger to NEGATIVE (NEG, N, –) ungrounded post
of battery. Connect POSITIVE (RED) clamp to vehicle chassis or engine
block away from battery. Do not connect clamp to carburetor, fuel lines, or
sheet-metal body parts. Connect to a heavy gauge metal part of the frame
or engine block.
5. When disconnecting charger, disconnect AC cord first, remove clamp from
vehicle chassis, and then remove clamp from battery terminal.
6. Do not charge the battery while the engine is operating.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2020 Wagan Corporation. All Rights Reserved.
6