Weka Teil 2 Instrucciones De Montaje página 7

- EN -
Dear customer, thank you for having chosen a weka product.
Please read these instructions carefully, so as to avoid incorrect installation or damage to the product.
IMPORTANT: Please check the consignment against the pack list to ensure that your weka product has arrived
safely and with all components included.
Do keep the pack list together with your receipt until the warranty period has expired, as it enables you to identify parts.
This makes it easier for us to deal with any queries or complaints you might have.
Please note that item numbers in the pack list do not correspond to the item number in this document.
If you sell the product, please hand the installation instructions, the pack list and any other relevant documents over to
the new owner.
These instructions and our products are subject to technical changes without prior notice. Your product might differ
slightly from that shown in the illustrations.
Safety information
Foundation
The ground under the weka – produkt or patio roof must be level and firm.
If you wish to install your weka product near slopes or on top of a basement, please consult a local builder for advice.
Risk of collapse!
Space requirements
The space required for your weka product depends on its size. As the product should be accessible from all sides for
regular inspection, keep a clearance of approx. 1.0 to 1.5 m around the product.
Safety instructions and warnings
To prevent accidents during assembly and installation, keep children away from the site.
Children under the age of 14 must at all times keep a distance of minimum 3 m from the installation site.
Observe all applicable accident prevention regulations.
For more information, please contact your builder.
To access the roof, always use load-distributing planks.
If you need to carry out work on the roof, use proper equipment (ladders, scaffolding, fall arresters) as required under the
applicable accident prevention regulations.
For detailed instructions, contact your local builder or safety authority. Always work in teams of at least two persons!
For the packing of the timber elements and installation we strongly recommend that you wear safety footwear and
protective gloves. When drilling and cutting timber, always wear safety goggles.
Unless specified otherwise in the product data sheet or in static strength calculations, the roof must be cleared in the
event of a snow load of 0.68kN/m², which corresponds to approx. 34 cm of snow.
Instructions for installation and use
Transport and storage
The product is shipped on pallets.
After unpacking and checking the consignment according to the pack list, store the components as follows:
Protect untreated timber against
prolonged direct sunlight humidity direct contact with ground
Techn. Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.  Copyright HRB 3662