Linea 2000 DOMO DO1950S Manual De Instrucciones página 29

www.domo-elektro.be
cool before putting on or taking off parts, and
before cleaning the appliance.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
• CAUTION: In order to avoid a hazard this
appliance must not be supplied through an
external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.
• Never leave the appliance unattended while it is functioning.
• Do not use or store this appliance outdoors.
• Do not use this appliance for other than intended use.
• Check carefully that the voltage and frequency of the power net match the
indications on the rating label of the appliance.
• The plug must be plugged into an appropriate outlet that is installed and grounded
in accordance with all local standards and requirements.
• Only use the utensils delivered with the appliance.
• Do not operate this appliance with a damaged cord or plug or in the event the
appliance malfunctions or has been damaged in any manner. Return the appliance
to the DOMO Service Department or its service agent for examination, repair, or
electrical or mechanical adjustment. Do not try to repair the appliance yourself.
• To protect against electrical shock or burns, do not immerse unit, cord, or plug in
water or other liquid.
• Do not operate the appliance with wet hands.
• A short power supply cord is provided to reduce the risk of becoming entangled in
or tripping over a longer cord. DO NOT USE WITH AN EXTENSION CORD.
• Unwrap the cord completely to prevent overheating of the cord.
• Do not let the power supply cord hang over the edge of a counter, or touch hot
surfaces.
• Do not allow the power cord supply to run underneath or around the unit.
• Make sure the appliance is correctly assembled, then plug the cord in the wall
outlet. To disconnect, turn controls to "OFF" or "0" position, then remove the plug
29
DO1950S