Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION WITHOUT DECK PLATE
6
6A
6B
6B
6 MOUNTING RINGS INSTALLATION
(For installation using the deck plate, go to step 4.)
If desired, place a small bead of plumber's putty to the underside of Mounting Rings (6A).
Place Mounting Rings (6A) onto Sink Holes (6B).
7
7H
7C
7E
7F
7 SPOUT INSTALLATION
Insert Lift Rod (7A) into hole at top of Spout Head (7B). Insert Spout Shank (7C) through
Spout Gasket (7D) and Center Sink Hole (7E). From underneath sink, place Thrust
Washer (7F) onto Spout Shank (7C) and tighten with Mounting Nut (7G). Before final
tightening, be sure Spout (7H) is centered and facing forward.
Caution: Do not over tighten!
6A
6A
6B
7A
7B
7D
7G
ENGLISH
8
8B
8E
8C
8D
8G
8 UNDERBODY INSTALLATION
From underneath, insert Underbody (8A) through end holes (8B), with shank labeled with
Red Tag (8C) on left side. Align Socket (8D) onto Spout Shank (8E), push Underbody
(8A) up until the top of Socket (8D) reaches the Spout Shank Stop (8E). Be careful not to
damage the O-Ring Seal (8F). Place Clip (8G) into Spout Shank Grove (8H) to secure unit.
9 HANDLE ADAPTER ATTACHMENT
3
8B
8B
8E
8A
8C
8D
8G
8B
8F
8A
8E
8G
8H
8F
Publicidad
