Emerio HO-132338.1 Manual De Instrucciones página 5

between first and second fins (near the front cover).
4. To attach the wheel mounting plate to the radiator body, you should insert the threaded ends of the U bolt
into the holes on the wheel mounting plate.
5. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
6. Repeat 3, 4 and 5 on the rear of radiator for mounting of the rear wheels.
Note: the rear wheels must be mounted between the end two fins.
USING THE APPLIANCE
Before using the appliance, make sure that it is on a flat and stable surface, damage may occur if it is
⚫
placed on an incline or decline.
Set the thermostat to the minimal position "-" and insert the plug to the power supply.
⚫
Slide the 3-in-1 switch to position "I".
⚫
Turn the thermostat knob in a clockwise direction to the maximum position "+".
⚫
Rotate the heat select knob to choose the suitable setting ("0": off / "I"= low heat / "II" = medium heat /
⚫
"III" = high heat). The indicator light illuminates.
After use, turn the thermostat knob to the minimal position "-" and the heat select knob to the position
⚫
"0". Unplug the appliance.
TIMER
A = Arrow pointer
B = Second hand (running as long as the appliance is plugged in)
Slide the 3-in-1 switch to position "
Firstly, set the current time. Rotate the outer ring of the timer in a clockwise
direction until the current time is lined up with the arrow pointer, i.e. if the
current time is 7 p.m., rotate the outer ring until the number 19 is in the line
with the arrow pointer.
Power on: Move the segments outward to the outer ring;
Power off: Move the segments inward to the center.
There are 4 segments between two adjacent time points, so each segment represents 15 minutes. Pull the
segments outward or inward to select your desired working time of the appliance.
For example, if you want to set the timer like below:
7:00 – 10:00 On
10:00 – 16:00 Off
16:00 – 20:00 On
20:00 – 7:00 Off
When the timer is set, the appliance will operate daily during the times programmed. Note: The appliance
must always be plugged into a power socket, the heat select knob must be rotated to position "I", "II" or "III"
and the thermostat shall be rotated to the maximum position "+" to ensure the heater will turn on successfully.
Note: When using the timer mode, ensure that the heater is not switched on unattended.
" to turn on the timer function.
Pull 12 segments between number 7 and 10 outward
Pull 24 segments between number 10 and 16 inward
Pull 16 segments between number 16 and 20 outward
Pull 44 segments between number 20 and 7 inward
- 4 -