Publicidad
Muestra el ejemplo
(cs2) # show port-channel 3/1
Local Interface................................ 3/1
Channel Name................................... ISL-LAG
Link State..................................... Up
Admin Mode..................................... Enabled
Type........................................... Static
Load Balance Option............................ 7
(Enhanced hashing mode)
Mbr
Device/
Ports
Timeout
------ ------------- --------- -------
0/13
actor/long
partner/long
0/14
actor/long
partner/long
0/15
actor/long
partner/long
0/16
actor/long
partner/long
4. Copie el
running-config
software y la configuración del switch.
Muestra el ejemplo
(cs2) # write memory
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Config file 'startup-config' created successfully .
Configuration Saved!
5. Habilite el segundo puerto de clúster, e2a, en cada nodo:
network port modify
Port
Port
Speed
Active
10G Full
True
10G Full
True
10G Full
True
10G Full
True
en la
startup-config
archivo cuando esté satisfecho con las versiones de
11
Publicidad
