12 Disposal and recycling
Notes for packaging
The packaging materials are re-
cyclable. Please dispose of pack-
aging
friendly manner.
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of separately!
• Used batteries or rechargeable batteries that are
not installed permanently in the old appliance must
be removed non-destructively before disposal! Their
disposal is regulated by the battery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
– Public disposal or collection points (e.g. munici-
pal works yards)
– Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
– Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to the
manufacturer without prior purchase of a new de-
vice from the manufacturer or taken to another
authorised collection point in your vicinity.
13 Troubleshooting
Fault
Possible cause
Motor does not work
Engine, cable or connector defec-
tive, mains fuses blown.
The engine runs slowly
Voltage too low, coils damaged,
and does not reach the
capacitor burnt.
operating speed.
Engine producing ex-
Coils damaged, motor defective.
cessive noise.
The engine does not
Circuits in the network are over-
reach full power.
loaded
etc.).
Motor overheats easily. Overloading of the motor, insuffi-
cient cooling of the motor.
26 | GB
in
an
environmentally
(lamps,
other
motors,
www.scheppach.com
– Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union and
which are subject to the European Directive
2012/19/EU. In countries outside the European
Union, different regulations may apply to the dispos-
al of waste electrical and electronic equipment.
Notes on lithium-ion batteries
Remove the battery before disposing of the
device!
• Do not dispose of the battery in household waste, in
a fire (risk of explosion) or in water. Damaged bat-
teries can harm the environment and your health if
toxic vapours or liquids escape.
• Defective or used batteries must be recycled in ac-
cordance with Directive 2006/66/EC.
• Hand in the device and the battery charger at a re-
cycling centre. The plastic and metal parts used can
be separated by type and thus recycled.
• Dispose of batteries when discharged. We recom-
mend covering the poles with an adhesive strip to
protect against a short circuit. Do not open the bat-
tery.
• Dispose of batteries according to local regulations.
Return batteries to a used battery collection point
where they can be recycled in an environmentally
friendly manner. Ask your local waste disposal com-
pany about this.
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check mains
fuses and replace as necessary
Have an electrician check the voltage. Arrange for in-
spection of the motor by a specialist. Arrange for re-
placement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other equipment or engines on the
same circuit.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.