Perel Tools CMD01 Manual Del Usuario página 3

Caution:
• The search coil's plug fits into the connector in only one way. Do not force the plug or you could damage it.
• To disconnect the search coil's cable from the detector, grasp the plug and pull it out of the connector. Never
tug at the cable.
7. Loosen the knob at the search coil's end and adjust the search coil to the desired
angle. (The search coil should be parallel with the ground). Tighten the knob just
enough to keep the search coil from rotating or wobbling.
Caution: Do not tighten the search coil too hard or use tools such as pliers to tighten
it.
8. Loosen the knob at the base of the handle, insert the arm support,
and tighten the knob.
b. Installing the Batteries
Caution:
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard, alkaline or rechargeable batteries of
different capacities).
1. If the detector is on, turn VOLUME (on the control housing) to OFF.
(The control clicks)
2. Press the right battery compartment cover's tab and slide the cover off in the direction of the
arrow.
3. Place a 9-volt battery into the battery compartment on top of the ribbon, matching the polarity
symbols (+ and -) marked inside.
4. Replace the right battery compartment cover.
5. Press the left battery compartment cover's tab and slide the cover off in the direction of the
arrow.
6. Place two 9-volt batteries into the battery compartment on top of the ribbons, matching the
polarity symbols (+ and -) marked.
7. Replace the left battery compartment cover.
Caution:
• Always remove old or weak batteries. They can leak chemicals that can destroy electronic parts.
• If you do not plan on using the detector for a week or more, remove the batteries.
• Dispose of old batteries promptly and properly.
You can extend battery life by using earphones, which require less power than the speaker.
c. Testing the Batteries
If the detector does not turn on, has weak volume,
will not tune properly, has erratic operation or drifts,
test the battery power.
CMD01_v2 PEREL