Fermax MINI 1PTA WG Manual De Usuario página 15

Cod. 97864 V09_17
BY REMOTE CONTROL
Notes:

Remote Control: Please use the Infrared Remote Control to program the controller. The
"IR" on the controller is the infrared receiving window, please direct the Remote Control to
it.

User ID number: Assign a user ID to the access card in order to track it. The common
user ID number can be any number fom 0~999. IMPORTANT: User IDs do not have to be proceeded with any
leading zeros. Recording of User ID is crical. Modifications to the
user require the User ID be available.

PIN: Can be any 4~6 digits except 8888 which is reserved.
For the users:
Enter and Exit Program mode
Programming Step
1. Enter Program Mode
2. Exit Program Mode
Set Master Code
Programming Step
1. Enter Program Mode
2. Update Master Code
3. Exit Program Mode
Add Users with Remote Control
Programming Step
Add Card User
1. Enter Program Mode
2. Add Card: Select Specific ID
(Allows Master to define a specific User ID to
associate the card to)
3. Exit Program Mode
Note: Users with a card have a default PIN code of 8888, which is not valid in card + PIN mode. It is necessary
to change default code for that mode of operation to see 'Change code' and 'Access mode'.
Add PIN User
1. Enter Program Mode
2. Add PIN: Select Specific ID
(Allows Master to define a specific
User ID to associate the PIN to)
3. Exit Program Mode
after entering the code confirm with dash (Eg: 9876#)
Keystroke Combination
* (Master Code) #
(Factory default is 123456
*
Keystroke Combination
* (Master Code) #
0（New Master Code）#（Repeat New
Master Code）# (code: 6 digits)
*
Keystroke Combination
* (Master Code) #
1 (User ID) # (Read Card on External
Reader) #
The user ID is any number from 0-999
*
* (Master Code) #
1 (User ID) # (Input PIN) #
The user ID is any number from 0-999
(PIN: 4~6 digits)
*
5