EDM Product 08473 Manual De Instrucciones página 23

USE OF DETERGENTS
The pressure washer will dispense detergent at low
pressure. Use the adjustable spray nozzle to rinse and
clean.
Biodegradable detergents are specifically formulated to
protect the environment and your pressure washer. These
detergents will not clog the filter and will protect the
internal parts of the pressure washer for longer life.
The built-in detergent dispenser will allow you to apply various types of
liquid detergent on the work surface. Detergent application occurs only
at low pressure. Insert the adjustable nozzle into the gun and adjust it to
the "LOW" end so that the pressure washer is in low pressure mode (see
Figure A below). Remove the cap from the detergent tank and fill the
tank with liquid detergent only (see Figure B below). Do not add water
to the tank. The pressure washer will automatically mix the water and
detergent. When you have finished applying the detergent to the work
surface, set it to the "HIGH" end of the adjustable nozzle and remove
detergent using the high pressure sprayer (see Figure A below). In high
pressure mode, the pressure washer will not dispense detergent.
WARNING: Never use products containing bleach, chlorine
or other corrosive materials, including solvent-based
liquids (e.g., gasoline, oils, etc.), trisodium phosphate
products, ammonia or acid-based cleaners. These
chemicals can cause damage to the unit and the surface
being cleaned. Always read the product label first.
CLEANING AND STORAGE
TURNING OFF THE PRESSURE WASHER
When you have finished using the pressure washer, follow these steps
to turn the unit off:
▶Turn the pressure washer to the OFF position.
▶Turn off the water supply.
▶Before disconnecting the high pressure hose connection, point the
gun in a safe direction and discharge the water under high pressure.
▶Disconnect the high pressure hose from the pressure washer and
the gun.
▶Disconnect the garden hose from the pressure washer.
▶Remove the quick coupling connector from the garden hose and
Instruction manual
▶Remove excess water from the pump by tilting the unit to both sides
▶Remove the water inlet filter and rinse it with water to remove any
▶Empty the detergent tank and rinse it under running water.
▶Clean any water residue from all parts and accessories.
▶Set the safety lock on the gun.
▶Store the pressure washer, parts and accessories in an area with a
WINTERIZING AND LONG-TERM STORAGE
Follow the shutdown procedure above, adding the following steps:
▶After disconnecting the water supply and before
▶Always store the pressure washer, parts and accessories in an area
MAINTENANCE
▶This pressure washer is supplied with a closed lubrication system, so
▶Check all hoses and fittings for damage before use.
▶Periodically check the inlet filter for debris. Clean this filter regularly
CLEANING TIPS
WOOD AND VINYL DECKS
Rinse the surface to be cleaned and the surrounding area with fresh
water. If you are using detergent, fill the detergent tank and apply
to the area you are cleaning at low pressure. For optimum results,
reduce your work area to smaller sections and clean each section
one at a time. Allow the detergent to sit on the surface for a few
minutes and then rinse at high pressure. Do not allow the detergent
23
attach it to the nozzle part of the connector installed on the pressure
washer for storage.
to drain the remaining water from the inlet and outlet fittings.
dirt or debris. Replace the filter once it is clean.
temperature above 0 °C (32 °F).
disconnecting the high pressure hose, switch on the pressure
washer for 2 to 3 seconds, until the remaining water in the
pump comes out.
WARNING: Turn the unit off immediately. Continued use of
the pressure washer without turning on the water supply
will cause severe damage to the unit!
with a temperature above 0 °C (32 °F).
WARNING: Failure to follow these storage instructions
could result in damage to the pump assembly.
it is not necessary to add oil.
for maximum performance.
WARNING: Always test spray in an area free of people and
objects before applying to the intended cleaning surface.
ref. 08473
ES
PT
EN
FR