Publicidad
Idiomas disponibles
Idiomas disponibles
to dry. Always wipe from left to right and top to bottom for best
results. High pressure rinse using fan spray, keeping the tip of the
ES
spray nozzle at least 15-25cm from the surface you are cleaning.
Maintain a greater distance from the surface when using a direct
spray. Caution: For softer woods, increase the distance from the
surface you are cleaning.
PT
CONCRETE, STONE AND BRICK PATIOS
Rinse the surface to be cleaned and the surrounding area with
fresh water. If using detergent, fill the detergent tank and apply
EN
to the area to be cleaned at low pressure. Rinse at high pressure
using the fan sprayer in a sweeping motion keeping the tip of
the spray nozzle at least 8-15cm from the surface to be cleaned.
Maintain a greater distance from the cleaning area when using a
straight sprayer.
FR
CARS, BOATS AND MOTORBIKES
Rinse the surface to be cleaned and the surrounding area with fresh
water. If using detergent, fill the detergent tank and apply to the area
to be cleaned at low pressure. For best results, clean one side at a
time. Let the detergent sit on the surface for a few minutes, but do
not allow it to dry. Rinse at high pressure using the fan sprayer in a
sweeping motion keeping the tip of the spray nozzle at least 20cm from
the cleaning surface. Maintain a greater distance from the cleaning area
when using a direct spray. Wipe the surface dry with a cloth to obtain
a polished finish.
BARBECUE GRILLS, ELECTRICAL EQUIPMENT AND GARDEN
TOOLS
Rinse the surface to be cleaned and the surrounding area with fresh
water. If using detergent, fill the detergent tank and apply to the
area to be cleaned under low pressure. Let the detergent sit on the
surface for a few minutes, but do not allow it to dry. Rinse at high
pressure using the fan sprayer keeping the tip of the spray nozzle
at least 2-8cm from the surface to be cleaned. Keep a greater
distance from the cleaning area when using a straight sprayer.
TECHNICAL DATA
Reference
Mains voltage
Mains frequency
Power
Nominal pressure
Max. pressure
Nominal flow
Max. water inlet pressure
Max. water inlet temperature
Instruction manual
WARRANTY
EDM guarantees all its products and declines all responsibility for
damage caused by incorrect installation / use of its products. This
warranty applies only if the instructions for use have been followed, and
is void if the appliance has been tampered with or used in an improper
and inadequate manner, or if it has been repaired by an unauthorised
person.
ENVIRONMENT
If you need to replace your machine after prolonged use, do not throw
it in the household waste, but dispose of it in an environmentally safe
manner.
HOW TO TROUBLE
THE SWITCH IS IN THE "I" POSITION BUT THE MACHINE WILL
NOT START
▶The socket is defective.
▶The voltage is inadequate.
▶The power cable is not plugged in.
PUMP DOES NOT REACH ADEQUATE PRESSURE OR
FLUCTUATES
▶Water inlet filter is clogged.
08473
▶Pump is sucking air.
230V
50Hz
▶Suction valves are clogged/worn.
2200W
120bar
▶Garden hose diameter is too small.
170bar
▶Water supply is restricted.
390 L/h
12bar
PRESSURE WASHER HAS OR WILL NOT HOLD PRESSURE
50°C
▶Excess air in water line and pump.
24
Sound pressure level measured according to ISO 3744:
LPA (sound pressure) dB (A)
KPA (sound pressure) dB (A)
LWA (sound power level) dB (A)
K WA (sound power) dB (A)
Weighted root mean square acceleration
value:
Check the plug, socket and fuses.
Check for proper voltage.
Connect the power cable.
Remove and clean the filter
Tighten connections/purge system.
Clean or replace valves.
Replace with 3/4" garden hose.
Check hose for kinks or leaks. The water supply tap is not fully open.
ref. 08473
90,3
3
105
3
< 2,65 m/s
2
Publicidad
