Giatsu VAW 2 Manual De Usuario E Instalacion página 61

 Install the power wire at least 3 feet (1 meter) away from televisions or radios to prevent
interference or noise. (Depending on the radio waves, a distance of 3 feet (1 meter) may not be
sufficient to eliminate the noise.)
 Please do not clean the unit when the power is on. When cleaning the unit, please turn off the
power after shutting down. Otherwise, you may be injured by a high- speed fan or electric
shock.
 Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
 Do not wash the unit. This may cause electric shocks or fire.
 Do not install the unit in the following places:
- Where there is mist of mineral oil, oil spray or vapors. Plastic parts may deteriorate, and cause them
to come loose or water to leak.
- Where corrosive gases (such as sulfurous acid gas) are produced. Where corrosion of copper pipes
or soldered parts may cause refrigerant to leak.
- Where there is machinery which emits electromagnetic waves. Electromagnetic waves can disturb
the control system and cause equipment malfunction.
- Where flammable gases may leak, where carbon fiber or ignitable dust is suspended in the air or
where volatile flammables such as paint thinner or gasoline are handled. These types of gases might
cause a fire.
- Where the air contains high levels of salt such as near the ocean.
- Where voltage fluctuates a lot, such as in factories.
- In vehicles or vessels.
- Where acidic or alkaline vapors are present.

This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Collection of such waste separately for special treatment is necessary. Do not dispose of electrical
appliances as municipal waste, use separate collection facilities. Contact your local government for
information regarding the collection systems available. If electrical appliances are disposed of in
landfills or dumps, hazardous substance can leak into the groundwater and get into the food chain,
damaging your health and well-being.
 Confirm the safety of the installation area ( walls, floors, etc. ) without hidden dangers such
as water, electricity, and gas before wiring/pipes.
 Before installation , check whether the user's power supply meets the electrical installation
requirements of unit ( including reliable grounding , leakage , and wire diameter electrical
load, etc. ). If the electrical installation requirements of the product are not met, the
installation of the product is prohibited until the product is rectified.
 Product installation should be fixed firmly, Take reinforcement measures, when necessary.
 When the unit has problems or peculiar smell, please do not continue to operate the unit.
Turn off the power immediately and stop the machine. Otherwise, electric shock or fire may be
caused.
 Please be careful when the product is not packaged or installed.
Harp edges can cut people. Take special care of the edges and fins of the heat exchanger.
 After installation or maintenance, please check whether the refrigerant or
refrigerant will leak.
If the refrigerant is insufficient, the unit will not work normally.
 He installation of external and internal machines must be flat and firm.
Avoid vibration and water leakage.
 Do not put your fingers into the fan and evaporator.
High speed fans can cause serious injury.
 In order to avoid the danger of inadvertently resetting the thermal breaker, the
equipment cannot use external switching devices, such as timers, or be connected to a
circuit that is often open or closed.
51