Pahlen Aqua spa 141650 Manual Del Usuario página 13

Electric heater Aqua spa
Start
Under no circumstances should the heater be started without it being completely filled with water.
1. Fill water in the pool to the correct level.
2. Start the pump for the pool water circulation.
3. Check that the water circulates normally in the system and that all air is drained from the system.
The heater must be completely water-filled before switching on the power. The heater can only be switched on when all air
is drained out of the system.
4. Test the heater by turning the thermostat knob back and forth. Make sure the thermostat contactor turns on and off.
Check the flow switch by closing the flow through the heater. The contactor should then switch off. Switch on the water again.
The contactor should then switch off.
5. Set the desired pool temperature with the thermostat knob.
6. The water is now heated to the set temperature.
Operation
When rewinding the filter, switch off the power to the heater.
If there is a risk of freezing, the power must be switched off and the heater must be emptied of all water.
Troubleshooting
1. Check the fuses.
2. Check that the system has the required flow through the heater.
3. For safety reasons, the heater's overheating protection is triggered in the absence of water or poor circulation. This is the
most common reason why the heater has "stopped working".
Check if the overheating protection has tripped and investigate the cause.
After the cause has been clarified and rectified, the overheating protection
is restored by:
35
37
- Unscrewing the protective cap (A).
- Pressing the reset button (B) on the junction box.
13
- Screw the protective cap back on.
12
4. Checking the heater function, see item 4 under "Start".
11
5. Adjusting the thermostat to a higher temperature.
6. If the problem persists: contact the installer. 10
9
8
26
24
28
27
Waste management and recycling
25
You must dispose of this product according to local laws and regulations.
Since this product contains electronic components, it must be disposed of separately from household waste. When this product
reaches the end of its life cycle, contact local authorities to find out more about waste management and recycling.
22 21
31
32
33
42
30
29
7
18
17
39 40
16
15 14
7
6
41
5
4
2
1
E
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
Surface treatment
The tolerance class in accordance with this Assembly drawing no.
part of ISO 2768-1
Aqua spa A15/20/30
13
(Elv spa plast)
Reservdelar
ENGLISH
B
A
Sid 2
Designed by: Drawn by: Date Approved by:
ASA 2010-12-22
Art.no. 14165X-03
Scale Revised by: Date
ASA 2019-07-10
Drawing number Rev.no.
M11354 5